I have a pair of Kartell Bourgie Lamps which I blogged about
here. The old Bourgie lamp has a very bad dimmer switch. It does not last long, which I also blogged about
here.
Thankfully, Kartell has a replacement dimmer switch is so much better than the original one. It is not cheap though but it is definitely worth the change.
|
I bought 2 replacement dimmer switch. |
|
The dimmer switch with instructions. |
|
The original dimmer switch on the left. The problem with it was the roller was very flimsy. The new switch is a slider. |
|
Another view. |
|
The back view. Its quite cool that it has PC board. |
|
Instructions with no words. |
|
Need to be careful in removing the original wire. |
|
On the left of the switch, it is indicated L for Live and N for Neutral. So the wire that is removed from L, I have labeled with Red tape, as can be seen on the bottom left hand corner. |
|
On the other side of the switch, take note of the N - Neutral wire. |
|
The broken switch that needs to be replaced, The Red labeled wire is the Live wire. |
|
The tools that I used for this project. |
|
The wires properly labeled. |
|
Using the spudger to lift up the slider switch. |
|
Once the slider is taken off, the 2 screws underneath needs to be removed. |
|
With the cover removed. |
|
With the white wire holder removed. You can see a small N letter on the bottom screw. |
|
So the blue wire goes to Neutral. |
|
With both ends connected. |
|
With the back screwed back and the slider in its place. |
|
Thankfully, it worked when turned on. |